done - set up robot, kb, mouse in office done - why am I not on the network? because /etc/dhcpcd.conf - had static address done - git pull - had to regenerate keys and do a bunch of silliness, but it worked eventually done - upgrade everything so that I can get flask to run done - run app done - add dispensing to quiz done - add 'used' list to not reuse a bird unless/until a new user. Or maybe, until all birds have been used.
done - - set/test amounts dispensed done - take pi and pumps out of existing robot done - pump 0 does not work. Pump 2 works in quiz and pump_test.py my daisy chained abortion of a ground wire was at fault.
done - Make new crimps for ground and signal wires. Don't daisy chain the grounds. Two ground wires, connected to two ground terminals on the motor hat. Tape over or rewire the ground wires. Possibly longer wires for the pumps
done - test again. check pump #s in code.
done - What should it do for network? I think you need to click on the network tab and connect
done - find clean tubing, wash it done - add documents to the README on getting code to run,
- done add requirements.txt done - vogel - change the root password
- logout from github in web
- copy pi image done - add fun desktop photo
- later, remove ssh key for robot from my github
done - Take pictures and document the pi, hat, and motors, in case wires come loose
-
remove my keyboard usb dongle before shipping.
-
weigh the package
-
find bubble wrap, and pack in it, probably a envelope or box from Post Office
-
pi and hat
-
2 pumps, wired
-
5 and 12 V power?
-
all screws/mounting hardware
-
confirm that Sandra can get a monitor, kb, mouse